PSC System 25xx
Components 2510 Clear Basecoat
2511 Repellant
2512 White Basecoat
2536 Forest Green Basecoat
2563 Tile Red Basecoat
PSC System 25xx is a proprietary water-soluble inorganic silicate based compound that deeply penetrates concrete surfaces to seal, densify, harden and waterproof them. It can be applied 7 to 10 days after the concrete has been poured; it is odorless and easy to apply. PSC 25xx Basecoats contain lithium.
Through a chemical reaction process PSC System 25xx develops internal bonds which densify the concrete substrate into a hard, chemically cured homogenous concrete mass that resists abrasion, protects concrete from spillage, animal fats, acids and repels water and oil contamination. This chemical reaction in concrete begins immediately after application and continues through the next six months.
The molecular structure of components of PSC System 25xx is perfectly adjusted to allow it to densify and harden the concrete while at the same time allowing the surface of concrete to breathe, thus permitting moisture vapor to transmit naturally into the air.
PSC System 25xx is safe to use, it’s odorless, VOC compliant formula permits its use in occupied areas without concern, and it can be applied in the proximity of foodstuffs. The deeply penetrating formula leaves no film and will not change the natural non-slip texture of the concrete floor.
PSC System 25xx is an economical alternative for concrete substrates, it will not yellow, chip, peel or show unsightly wear patterns with use; there will be no tire marks. The more PSC System 25xx is used, and the older the treated surface gets, the better it will look.
PSC System 25xx can be applied approximately 7 days following final finishing operation of the new concrete surface after all surface water has evaporated and the concrete surface is hard. There is no need for an acrylic, resin curing compound or sealer.
PSC System 25xx is approved by CFIA (Canadian Food Inspection Agency) for use in Registered Establishments handling and processing food stuffs.
PSC 2511 Repellant is clear water based penetrating sealer to be used as topcoat for PSC System 25xx. It repels the intrusion of water, salts, food acids, oil and de-icer salts into concrete substrates. It can be applied with a low pressure or airless sprayer followed by backrolling with a 1/4" nap roller.
PSC 2551 Concrete Modifier “R” is a proprietary polymer additive for concrete and mortars. It improves both bond strength and abrasion resistance of concrete up to 500 %. Typical thickness of application is ¼ “ including dry components and PSC 2551. Concrete modified with PSC 2551 can be used for interior or exterior applications. PSC 2551 is specifically engineered for patterned overlays, exhibiting a more rigid structure which allows it to adjust the substrate perfectly into various patterned moulds.
PSC 26xx PolyRock Overlay (topping) System. PSC 26xx PolyRock materials are engineered with Portland cement and select, proprietary high performance polymers. They readily bond to concrete surfaces, indoors or outdoors, and provide a new concrete look for worn, spalled or gouged concrete surfaces. PSC 26xx materials are easy to apply, they harden quickly, they are freeze/thaw resistant and they produce a surface finish which is suitable for heavy rubber wheel traffic.
PSC 26xx PolyRock System can be colored, either with pigment mixed into the wet slurry or with concrete stain after the substrate has hardened. It can be textured or patterned; it can turn ordinary concrete into dramatic, eye catching surface, making it a great alternative to brick and stone installations. It readily bonds to concrete surfaces, horizontal or vertical, and can be applied by trowel, squeegee or sprayer. Once applied, PSC 26xx system can be broom textured before it sets for a reduced-slip surface.
